3/11/2023 0 Comments Lego to tetrix 3d![]() Secure them the outermost holes on the channels, making the motors as far apart as possible so that you will be able to attach the motor cables later. Take the two motors and attach them to the underside of the base, using the long motor mount screws. Now repeat this procedure with another motor, motor mount, motor shaft hub, and wheel, so that you have two wheels that are ready to be mounted to the base of your robot. Once you have the motor mount on the motor, attach the shaft hub by sliding it onto the axle and tightening the screw into the flat part of the axle.Īttach the wheel to the motor axle mount with two screws. This may take a bit of force as the motor mount is designed to fit snugly. ![]() Slide the motor mount around the front of the motor until the leading edge of the motor mount is flush with the crack in the motor housing, as seen in the picture. Take a DC motor, a motor mount, a motor shaft hub and a wheel from your kit. Use the hex key to tighten fully.Īlso attach the servo controller to the base in the same way on the other side. Feed the screw down through the top and attach a nut on the bottom. Fasten the controller, plate, and channel together with a screw and nut. Take the DC Motor Controller from your kit and line it up with two of the four holes that line up on one side of your robot. There should be four small holes in the plate that line up with four small holes in each channel. Begin by taking the two channels and the plate from your kit, and position them so that the open sides of the channels are facing towards each other.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |